ICOM BC-152 Charger Instruction Manual

1. Gabatarwa

This manual provides essential instructions for the safe and efficient operation of your ICOM BC-152 charger. Please read this manual thoroughly before using the charger to ensure proper setup, operation, and maintenance. Keep this manual for future reference.

2. Bayanin Tsaro

Always observe the following safety precautions to prevent injury, damage to the charger, or damage to the device being charged.

• Use only with compatible ICOM battery packs. Using incompatible batteries may cause fire, explosion, or injury.
• Kada a fallasa na'urar caji ga ruwan sama, danshi, ko yanayin zafi mai tsanani.
• Kar a sake haɗawa ko gyara caja. Koma duk hidima ga ƙwararrun ma'aikata.
• Tabbatar da wutar lantarki voltage matches the charger's specifications.
• Tsare caja daga tushen zafi da hasken rana kai tsaye.
• Cire caja daga wurin wutar lantarki lokacin da ba a amfani da shi ko kafin tsaftacewa.

3. Saita

3.1 Buɗewa

Carefully remove the ICOM BC-152 charger from its packaging. Verify that all components are present:

• ICOM BC-152 Charger Unit
• AC Adapter (if included)
• Manual Umarni (wannan takarda)

Figure 1: The ICOM BC-152 charger unit. This image shows the compact black charger with a single slot for a battery pack.

3.2 Haɗin Wuta

1. Connect the AC adapter cable to the DC input jack on the rear of the BC-152 charger unit.
2. Toshe adaftar AC cikin daidaitaccen wurin bangon bango.
3. Yanzu an shirya caja don amfani.

4. Umarnin Aiki

4.1 Charging a Battery Pack

Follow these steps to charge a compatible ICOM battery pack:

1. Ensure the charger is connected to a power source as described in Section 3.2.
2. Carefully insert the battery pack into the charging slot of the BC-152 charger. Ensure it is seated firmly.
3. Observe the charging indicator light.

4.2 Hasken Nuni

The BC-152 charger features an LED indicator to show the charging status:

• Ja (Mai ƙarfi): Batirin yana caji a halin yanzu.
• Kore (Mai ƙarfi): Charging is complete. The battery pack is fully charged.
• Ja mai walƙiya: Charging error or battery fault. Remove the battery and re-insert. If the error persists, consult the troubleshooting section.
• Babu Haske: Charger is not connected to power, or no battery is inserted.

Charging time may vary depending on the battery's capacity and its current charge level. Typically, a fully depleted battery will take approximately 2-4 hours to charge.

5. Kulawa

5.1 Tsaftacewa

Don kiyaye kyakkyawan aiki da bayyanar:

• Always unplug the charger from the power outlet before cleaning.
• Yi amfani da kyalle mai laushi da busasshe don goge wajen caja.
• Kada a yi amfani da masu tsabtace abrasive, kaushi, ko sinadarai masu tsauri.
• Ensure no moisture enters the charging slot or power input.

5.2 Adana

When not in use for extended periods, store the charger in a cool, dry place, away from direct sunlight and extreme temperatures. Disconnect it from the power supply.

6. Shirya matsala

If you encounter issues with your BC-152 charger, refer to the table below for common problems and solutions.

7. Ƙayyadaddun bayanai

Note: Specifications are subject to change without notice for improvement.

8. Garanti Bayani

ICOM products are manufactured with high-quality components and are subject to rigorous quality control. This product is covered by a limited warranty against defects in materials and workmanship. The specific terms and duration of the warranty may vary by region. Please refer to the warranty card included with your purchase or visit the official ICOM webshafin don cikakken bayanin garantin.

This warranty does not cover damage caused by misuse, accident, unauthorized modification, or improper installation.

9. Tallafin Abokin Ciniki

If you have any questions, require technical assistance, or need to report a problem that cannot be resolved using the troubleshooting guide, please contact ICOM customer support.

ICOM America Inc.
Visit ICOM America's Contact Page
Please have your product model (BC-152) and serial number ready when contacting support.