Gabatarwa
This manual provides detailed instructions for the safe installation, operation, and maintenance of your Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle, Model 5225. This device combines a single-pole switch and a 15 Amp, 125 Volt grounding receptacle in a single unit, designed for commercial and residential applications.
Bayanin Tsaro
GARGADI: To avoid fire, shock, or death, turn off power at the circuit breaker or fuse box and test that power is off before wiring. This device must be installed in accordance with all national and local electrical codes.
- Always disconnect power before working on electrical circuits.
- Use only copper or copper-clad wire. Do not use aluminum wire with this device.
- Tabbatar cewa duk haɗin waya amintattu ne.
- Idan bakada tabbas game da kowane bangare daga cikin wadannan umarnin, sai ka tuntubi kwararren masanin lantarki.
- Wannan na'urar don amfanin cikin gida ne kawai.
Abubuwan Kunshin
- One Leviton 15 Amp, 120 Volt, Duplex Style Combination Single Pole Switch/Receptacle (Model 5225-W)
Saita da Shigarwa
- Kashe Wuta: Locate the circuit breaker or fuse that supplies power to the outlet box where you intend to install the device. Turn it OFF. Verify power is off using a voltage gwajin.
- Remove Old Device (if applicable): Carefully remove the existing switch or receptacle from the wall box. Disconnect the wires, noting their connections.
- Shirya Wayoyi: Strip approximately 1/2 inch (12.7 mm) of insulation from each wire end. Ensure wires are straight.
- Gano Tashoshi: The Leviton 5225 device has the following terminals:
- Green Ground Screw: For the bare copper or green insulated ground wire.
- Silver Screws: For neutral (white) wires.
- Brass Screws: For hot (black) wires.
- Break-off Tabs: Located on the side of the device, these tabs connect the switch and receptacle to the same hot feed. If you need to control the switch and receptacle from separate power sources, carefully break off the tab connecting the brass screws.
- Haɗin Waya:
Wayar Kasa: Connect the bare copper or green insulated ground wire from the wall box to the green ground screw on the device. Tighten securely.
Waya Ta Tsakiya: Connect the white neutral wire from the wall box to one of the silver screws. Tighten securely.
Hot Wire (Power In): Connect the black hot wire (power source) from the wall box to one of the brass screws. Tighten securely.
Load Wire (for Switch): If the switch controls a light fixture or other load, connect the load wire to the remaining brass screw. If the switch and receptacle are on the same circuit, and the break-off tab is intact, the switch will control the receptacle. If the tab is broken, the switch will control a separate load connected to its brass screw, and the receptacle will be constantly powered.
- Dutsen Na'ura: Carefully fold the wires into the wall box. Secure the device to the wall box using the provided mounting screws.
- Install Wallplate: Attach a standard wallplate (not included) over the device.
- Dawo da Power: Turn the power back ON at the circuit breaker or fuse box.
- Gwaji: Test the switch and receptacle functionality.
Hoto 1: Gaba view of the Leviton 5225 combination switch and receptacle, showing the single pole switch at the top and the 15 Amp receptacle below.
Hoto na 2: Baya view of the Leviton 5225, illustrating the brass (hot), silver (neutral), and green (ground) wiring terminals, along with the break-off tab. The UPC 0078477965849 is visible.
Umarnin Aiki
The single-pole switch operates by toggling the lever up or down to control the connected load. The 15 Amp receptacle functions as a standard electrical outlet for plugging in devices. If the break-off tab is intact, the switch will control power to the receptacle. If the tab is removed, the switch and receptacle operate independently.
Kulawa
This device requires minimal maintenance. Periodically inspect the device and wallplate for any signs of damage or wear. Clean with a soft, dry cloth. Do not use abrasive cleaners or solvents.
Shirya matsala
- No Power to Receptacle/Switch: Check the circuit breaker or fuse. Ensure all wire connections are secure.
- Switch Not Controlling Receptacle: Verify that the break-off tab between the brass screws is intact if you intend for the switch to control the receptacle.
- Sake-sake Haɗi: If the device feels loose in the wall box, ensure mounting screws are tightened.
Ƙayyadaddun bayanai
| Siffar | Ƙayyadaddun bayanai |
|---|---|
| Lambar Samfura | 5225-w |
| Voltage | 120 Volts |
| Ampzamanin | 15 Amp (Switch), 15 Amp (Takarda) |
| Nau'in Canjawa | Sansanin sanda guda ɗaya |
| Nau'in karba | Duplex Style, Grounding |
| Kayan abu | Thermoplastic |
| Launi | Fari |
| Girma | 1.97 x 0.39 x 1.18 inci; 2.4 oz |
| Amincewa | UL 20, CSA C22.2 |
Hoto 3: Gefe view of the Leviton 5225, showing approximate dimensions of 4.4 inches (11 cm) in length.
Bayanin Garanti
Leviton provides a limited two-year warranty for this device. For specific details regarding warranty coverage and claims, please refer to the official Leviton website ko tuntuɓi goyon bayan abokin ciniki.
Taimako
For technical assistance, product information, or customer service, please visit the official Leviton website or contact their customer support department. You can find contact information and additional resources at www.leviton.com.
